Owner, Custom Made Aug 16, 2016

I replaced a Dunkirk XEB-3 (20 yrs. old) with the Dunkirk boiler above. The new one is all most identical to the old one, that is the pipes were located same as the old, so gas and water lines were easily plumbed. The old electrical wires could be used although lengthened to connect to the digital controls. The circulators location has changed, it's still provided with its wiring provided. Venting is the same as the old one. I was happy to get another Dunkirk that installed easily.

Great Heater! Sep 29, 2016

This little heater does a wonderful job of keeping my two car garage nice and warm all winter long. I use my garage for a man-cave workshop in addition to parking my vehicles. I purchased this one because 15 years ago I purchased an ADP similar model. Well, after 15 well used years of 247 running, the board went out. So, instead of replacing the board I opted to replace the unit with another ADP. I don't think you can ask for many more trouble free years from any heater.

Nice Panel Radiator Aug 28, 2016

I just wish it was more simple to figure out which connectors were needed. The description should be simpler. All I wanted was 1/2" copper connections but somehow the unit showed up with PEX connections. Overall good radiator though.

Worth It Aug 14, 2016

Pretty easy install with 2 people. Cools down my 1200 sqft home in about 30 min. Worth the cost.

A Great Little Fan Sep 04, 2016

I bought this in-line fan to pump warm air into a chase containing hot and cold water pipes. When outdoor temperatures drop below 15 degrees Fahrenheit, the air in the chase falls below freezing, so I was worried that the pipes would freeze. This little fan together with flex duct (I stripped away the outer insulation) solved the problem. I have a thermostat in the chase and a control system that turns on the fan when the chase temperature drops below 40 degrees F. Now I can spend time... more