Seeley May 31, 2016

Very easy to install... working great... no issues... If this works as good as it is now for the next 10 years, as it is warrantied for, I will be getting another just like it... Wonderful furnace!

Great Heater I'd Buy Again😎 Aug 23, 2016

I replaced my old Modine heater, with a new Modine heater and it works great. The old one, the only thing that went wrong with it, was one of the fan blades broke in half . The old one , didn't owe me nothing, I had it in my shop for 38 years.

Just In Time Oct 21, 2016

Loving the new AC. Thanks eComfort.

Warmwire Heated Floor Jun 02, 2016

I installed a WarmWire heated floor in a 6'x8' coat room that had no other source of heat. It is on a concrete slab with 2 outside walls and a wall to an unheated attached garage. I glued 2 6mm thick sheets of Cerazorb synthetic cork directly on the concrete. It was super easy to lay the wire on top on the cork using the metal clip system provided. To be safe, I laid a sheet of 1/4" luan plywood on top of the wires while laying the tile. I checked the resistance in the wires at each step... more

Owner, Custom Made Aug 06, 2016

I replaced a Dunkirk XEB-3 (20 yrs. old) with the Dunkirk boiler above. The new one is all most identical to the old one, that is the pipes were located same as the old, so gas and water lines were easily plumbed. The old electrical wires could be used although lengthened to connect to the digital controls. The circulators location has changed, it's still provided with its wiring provided. Venting is the same as the old one. I was happy to get another Dunkirk that installed easily.